Hi, > > > -----Original Message----- > > From: Dieter Kiermaier [mailto:dk-arm-li...@gmx.de] > > Sent: Thursday, July 09, 2009 12:50 PM > > To: Prafulla Wadaskar > > Subject: Re: [U-Boot] [PATCH2/2] Sheevaplug: Add Kirkwood > > gpio support to Sheevaplug > > > > Hi Prafulla, > > > > > > > > > -----Original Message----- > > > > From: Dieter Kiermaier [mailto:dk-arm-li...@gmx.de] > > > > Sent: Thursday, July 09, 2009 12:25 PM > > > > To: Jean-Christophe PLAGNIOL-VILLARD > > > > Cc: u-boot@lists.denx.de; Prafulla Wadaskar > > > > Subject: Re: [U-Boot] [PATCH2/2] Sheevaplug: Add Kirkwood gpio > > > > support to Sheevaplug > > > > > > > > Hi Jean, hi Prafulla, > > > > > > > > here the corrected version. > > > > > > > > Many thanks, > > > > Dieter > > > > > > > > > On 14:45 Mon 29 Jun , Dieter Kiermaier wrote: > > > > > > Hi, > > > > > > > > > > > > patch 2 of 2 which adds Kirkwood GPIO support to Sheevaplug. > > > > > > Any comments are welcome! > > > Hi Dieter > > > Thanks for your efforts > > > That's good, gpio driver is supported for Kirkwood but, > > Again question > > > remains the same- Why do you need gpio support on > > Sheevaplug? Whereas you have no evidence to use it. > > > > That's a good question :) > > I need gpio support for my own board which will come up the > > next 2 months. > > So maybe you're right. There is no need for GPIO support on > > SheevaPlug. > Well.. you better post separate patch for your board that needs to use gpio > support. > Would be the best solution. Is there anything I have to know if I want u-boot to support my own board?
> > On the other hand there are maybe some hackers out there > > using sheevaplug not only as it is. So maybe there is a need > > for some GPIO bitbanging? > > At least if you open the case :) > I will post this information on plug forum > (http://plugcomputer.org/plugforum/index.php). > Also a small how-to doc to uses gpio support for bit bang interface. > Good idea. > > > > Also many thanks to all of you out there for such a nice boot > > loader :) Dieter > Thanks to yourself too :-) let's make it further better. > Yep. Dieter > Regards. > Prafulla . . > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot