Remove the check for temperature being within the min/max range and enter the busywait cooling loop whenever the CPU temperature is over the critical temp. This fixes the issue where if a board was booted at a temp greater than the CPU temperature max, it would skip the loop and never indicate or try to address the overtemp issue.
Cc: Ye Li <b37...@freescale.com> Cc: Jason Liu <r64...@freescale.com> Signed-off-by: Tim Harvey <thar...@gateworks.com> --- drivers/thermal/imx_thermal.c | 16 ++++++---------- 1 file changed, 6 insertions(+), 10 deletions(-) diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c index 0d893c9..42ca8d0 100644 --- a/drivers/thermal/imx_thermal.c +++ b/drivers/thermal/imx_thermal.c @@ -130,16 +130,12 @@ int imx_thermal_get_temp(struct udevice *dev, int *temp) int cpu_tmp = 0; cpu_tmp = read_cpu_temperature(dev); - while (cpu_tmp > priv->minc && cpu_tmp < priv->maxc) { - if (cpu_tmp >= priv->critical) { - printf("CPU Temperature (%dC) too close to max (%dC)", - cpu_tmp, priv->maxc); - puts(" waiting...\n"); - udelay(5000000); - cpu_tmp = read_cpu_temperature(dev); - } else { - break; - } + while (cpu_tmp >= priv->critical) { + printf("CPU Temperature (%dC) too close to max (%dC)", + cpu_tmp, priv->maxc); + puts(" waiting...\n"); + udelay(5000000); + cpu_tmp = read_cpu_temperature(dev); } *temp = cpu_tmp; -- 1.9.1 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot