Some NAND controllers define custom functions to read data out,
respect this in order to correctly support bad block handling in
simple SPL NAND framework.
NAND controller specific read_buf() is used even to read 1 byte in
case of connected 8-bit NAND device, it turns out that read_byte()
may become outdated.
Signed-off-by: Vladimir Zapolskiy <v...@mleia.com>
---
drivers/mtd/nand/nand_spl_simple.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/mtd/nand/nand_spl_simple.c
b/drivers/mtd/nand/nand_spl_simple.c
index 700ca32..e69f662 100644
--- a/drivers/mtd/nand/nand_spl_simple.c
+++ b/drivers/mtd/nand/nand_spl_simple.c
@@ -115,6 +115,7 @@ static int nand_command(int block, int page, uint32_t offs,
static int nand_is_bad_block(int block)
{
struct nand_chip *this = mtd.priv;
+ u_char bb_data[2];
nand_command(block, 0, CONFIG_SYS_NAND_BAD_BLOCK_POS,
NAND_CMD_READOOB);
@@ -123,10 +124,12 @@ static int nand_is_bad_block(int block)
* Read one byte (or two if it's a 16 bit chip).
*/
if (this->options & NAND_BUSWIDTH_16) {
- if (readw(this->IO_ADDR_R) != 0xffff)
+ this->read_buf(&mtd, bb_data, 2);
+ if (bb_data[0] != 0xff || bb_data[1] != 0xff)
return 1;
} else {
- if (readb(this->IO_ADDR_R) != 0xff)
+ this->read_buf(&mtd, bb_data, 1);
+ if (bb_data[0] != 0xff)
return 1;
}
--
2.1.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
