Hi Peng, On Mon, Jul 20, 2015 at 8:28 AM, Peng Fan <peng....@freescale.com> wrote: > 1. Add USDHC, I2C, UART, 74LV, USB, QSPI support. > 2. Support SPL > 3. CONFIG_MX6UL_14X14_EVK_EMMC_REWORK is introduced, this board default > supports sd for usdhc2, but can do hardware rework to make usdhc2 support > emmc. > > Boot Log: > U-Boot SPL 2015.07-rc3-00124-g35d727b (Jul 20 2015 - 18:40:59) > reading u-boot.img > reading u-boot.img > > U-Boot 2015.07-rc3-00124-g35d727b (Jul 20 2015 - 18:40:59 +0800) > > CPU: Freescale i.MX6UL rev1.0 792 MHz (running at 396 MHz) > CPU: Commercial temperature grade (0C to 95C)CPU: Thermal invalid data, > fuse: 0x0 > - invalid sensor device > Reset cause: POR > Board: MX6UL 14x14 EVK > I2C: ready > DRAM: 512 MiB > MMC: FSL_SDHC: 0, FSL_SDHC: 1 > *** Warning - bad CRC, using default environment > > In: serial > Out: serial > Err: serial > Net: CPU Net Initialization Failed > No ethernet found. > Hit any key to stop autoboot: 0 > > Signed-off-by: Peng Fan <peng....@freescale.com>
I am running u-boot-imx tree that has this patch applied, but I am not able to boot from SD card: U-Boot SPL 2015.07-22910-g1c23c1e (Aug 10 2015 - 16:17:50) MMC: no card present spl: mmc init failed with error: -16 ### ERROR ### Please RESET the board ### Any ideas? Regards, Fabio Estevam _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot