Hi all, this patch adds basic support for NI Ettus Research E3XX series boards. I tagged this RFC because I'm not sure if the boards/xilinx/zynq subdirectory is the correct place for this, as I'll have some follow up patches that read the devices EEPROM for ethernet address etc.
Would putting it under boards/ni/zynq be the correct way of integrating it? While technically a Zynq device there are a lot of custom modifications, that I wouldn't like to force into board/xilinx/zynq/board.c in my follow up patches. However duplicating the entire board.c doesn't seem like a good idea neither. Any suggestions? For future reference do you want me to split out dts etc in a separate patch? Thanks for your feedback & suggestions, Moritz Moritz Fischer (1): zynq: Add support for E3xx board. arch/arm/dts/Makefile | 3 +- arch/arm/dts/zynq-e3xx.dts | 35 + arch/arm/mach-zynq/Kconfig | 4 + board/xilinx/zynq/Makefile | 2 + board/xilinx/zynq/e3xx_hw_platform/ps7_init_gpl.c | 13446 ++++++++++++++++++++ board/xilinx/zynq/e3xx_hw_platform/ps7_init_gpl.h | 130 + configs/zynq_e3xx_defconfig | 12 + include/configs/zynq_e3xx.h | 29 + 8 files changed, 13660 insertions(+), 1 deletion(-) create mode 100644 arch/arm/dts/zynq-e3xx.dts create mode 100644 board/xilinx/zynq/e3xx_hw_platform/ps7_init_gpl.c create mode 100644 board/xilinx/zynq/e3xx_hw_platform/ps7_init_gpl.h create mode 100644 configs/zynq_e3xx_defconfig create mode 100644 include/configs/zynq_e3xx.h -- 2.5.1 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
