This driver generates clearly debugging prints when changing clock speed, so silence those. Furthermore, the driver generates further prints in case a command fails to complete. The later case woud be useful, but for eMMC, command 8 can fail and it's not an error but a part of the specification. Thus, make this debug() as well.
Signed-off-by: Marek Vasut <ma...@denx.de> --- drivers/mmc/gen_atmel_mci.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/mmc/gen_atmel_mci.c b/drivers/mmc/gen_atmel_mci.c index 45bcffb..2815e57 100644 --- a/drivers/mmc/gen_atmel_mci.c +++ b/drivers/mmc/gen_atmel_mci.c @@ -48,8 +48,8 @@ static unsigned int atmel_mci_get_version(struct atmel_mci *mci) */ static void dump_cmd(u32 cmdr, u32 arg, u32 status, const char* msg) { - printf("gen_atmel_mci: CMDR %08x (%2u) ARGR %08x (SR: %08x) %s\n", - cmdr, cmdr&0x3F, arg, status, msg); + debug("gen_atmel_mci: CMDR %08x (%2u) ARGR %08x (SR: %08x) %s\n", + cmdr, cmdr & 0x3F, arg, status, msg); } /* Setup for MCI Clock and Block Size */ @@ -73,7 +73,7 @@ static void mci_set_mode(struct mmc *mmc, u32 hz, u32 blklen) clkodd = clkdiv & 1; clkdiv >>= 1; - printf("mci: setting clock %u Hz, block size %u\n", + debug("mci: setting clock %u Hz, block size %u\n", bus_hz / (clkdiv * 2 + clkodd + 2), blklen); } else { /* find clkdiv yielding a rate <= than requested */ @@ -81,7 +81,7 @@ static void mci_set_mode(struct mmc *mmc, u32 hz, u32 blklen) if ((bus_hz / (clkdiv + 1) / 2) <= hz) break; } - printf("mci: setting clock %u Hz, block size %u\n", + debug("mci: setting clock %u Hz, block size %u\n", (bus_hz / (clkdiv + 1)) / 2, blklen); } -- 2.1.4 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot