Hi Dirk, On 28 October 2015 at 04:46, <dirk.eib...@gdsys.cc> wrote: > From: Dirk Eibach <dirk.eib...@gdsys.cc> > > > > > Dirk Eibach (17): > i2c: ihs_i2c: Dual channel support > i2c: ihs_i2c: Use macro bestpractices > i2c: ihs_i2c: Fix hold_bus control > board: gdsys: Configure DP501 SPDIF input > board: gdsys: Increase DP501 I2C retry interval > board: gdsys: Consider DP501 limits on link training > dlvision-10g: Support displayport > controlcenterd: Disable sideband clocks > hrcon: Remove CH7301 configuration > mpc83xx: Add strider board > hrcon: Use generic ioep-fpga support > hrcon: Fix videoboard i2c setup > hrcon: Add support for the DH variant > hrcon: Add fan controllers > board: gdsys: Add osdsize command > board: gdsys: Enable osd on output only > i2c: soft_i2c: Fix bus indizes > > Reinhard Pfau (1): > iocon: reset FPGAs in last_stage_init()
Would this be a good opportunity to convert these boards over to driver model for I2C? Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
