Hello Hans, Nice to see it boots from SD, after clock stable changes.:)
On Thu, Dec 10, 2015 at 6:22 PM, Hans de Goede <hdego...@redhat.com> wrote: > Hi, > > On 11/30/2015 04:39 PM, Vishnu Patekar wrote: >> >> Hello Hans, >> >> >> >> On Mon, Nov 30, 2015 at 4:13 PM, Hans de Goede <hdego...@redhat.com> >> wrote: >>> >>> Hi Vishnu, >>> >>>> This patch v2 of series that adds basic support for Allwinner A83T SOC >>>> with >>>> review comments addressed. >>> >>> >>> Can you provide some quick instructions on how to test this on the >>> A83T HomletV2 ? >>> >>> With v1 of these patches I tried to just build them and dd them to >>> the sdcard, but that did not work. >>> >>> In the mean time I've figured out that I can get a serial console >>> with the firmware in the nand using a sdcard breakout board, so >>> I should be able to enter FEL mode by pressing 2 there, but it would >>> be really nice if the board would just boot from sdcard... >>> >> I broke microsd connector of my A83T board, so boot from microsd not >> tested. >> >> As you have microSD breakout UART working, you can set >> CONFIG_UART0_PORT_F=y and use FEL mode, commands as below >> sunxi-fel spl u-boot-sunxi-with-spl.bin >> sunxi-fel write 0x4a000000 u-boot-dtb.bin >> >> This is how i have tested it for now. > > > Ok, I've managed to get things to work actually cold booting from the > sdcard slot (so as to not rely on earlier setup done by boot0 before > it enters FEL mode when pressin '2'). In order to get the sdcard + > cold booting to work I had to make some changes to the clk code: > > https://github.com/jwrdegoede/u-boot-sunxi/commit/03cf8b8354f732fe34fc34ef44fecd79190f019e > > With these fixes A83 support seems to work well, good job! > > I've merged this into my sunxi-wip tree now and I'm preparing a pull-req > to send this upstream. > > Regards, > > Hans > > > p.s. > > Next time please make sure to base your patches on the latest official > master, when you posted these patches master already had H3 support, > and I had to do quite a but of manual conflict resolving because of that. Sorry about that, I'll take care of this in future. Regards, Vishnu _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot