Dear "Dexdyne Postmaster", In message <memo.20090811100114.121...@postmaster+dexdyne.com.cix.co.uk> you wrote: > > In development, it's a bit of a pain that installing a new u-boot image > with different settings for bootargs and bootcmd doesn't actually change > anything, because the environment in flash is still valid.
This depends on your configuration. When using an "embedded" environment, this will get replaced with each install. > Worse, there doesn't seem to be a command to say "over-write that with > your new defaults" You can run a script image that does whatever you want. > If that is indeed so, then can I propose such a command should be added? Search the archives. There has been a proposal before, and even an API has been agreed on, it's just that nobody implemented it yet. Patches are welcome. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de The universe does not have laws - it has habits, and habits can be broken. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
