Hi, York,
All the boards are required to set to Intel mode. If it’s not
in Intel mode, VID is not support.
I have a look how to do.
Thanks.
From: york sun
Sent: Thursday, January 21, 2016 10:53 AM
To: Ying Zhang; ying.zh...@freescale.com; u-boot@lists.denx.de
Subject: RE: [PATCH] board/t4240rdb: VID support
Can software detect IR mode and support both? Or skip the vid part if the mode
is not supported?
York
-------- Original Message --------
From: Ying Zhang <ying.zhang22...@nxp.com<mailto:ying.zhang22...@nxp.com>>
Sent: Wednesday, January 20, 2016 06:05 PM
To: york sun
<york....@nxp.com<mailto:york....@nxp.com>>,ying.zh...@freescale.com,u-boot@lists.denx.de
Subject: RE: [PATCH] board/t4240rdb: VID support
Hi, York,
I know this issue. It's occurred because the IR chip on T4RDB worked on AMD
mode, it can work well on INTEL mode.
Nexcom will collect all the boards and set the IR chip to INTEL mode.
Before that, What should we do?
Thanks.
-----Original Message-----
From: york sun [mailto:york....@nxp.com]
Sent: Thursday, January 21, 2016 6:29 AM
To: ying.zh...@freescale.com<mailto:ying.zh...@freescale.com>;
u-boot@lists.denx.de<mailto:u-boot@lists.denx.de>
Subject: Re: [PATCH] board/t4240rdb: VID support
On 01/20/2016 02:26 PM, york....@nxp.com<mailto:york....@nxp.com> wrote:
<snip>
> Ying,
>
> This patch looks OK but the board doesn't work. I traced the code to
> the first setting voltage. The VID has 1025mV and current voltage is
> 1047mV. As soon as the code drops voltage by one step, the board
> hangs. Please double check if the voltage setting is correct. You can measure
> it on the board to confirm.
>
I tested it on top of b57843e68804c2d53d2cff2b8b2238e37b388faa, with two boards.
The result is the same.
York
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
