Hi, On 3 May 2016 at 00:39, Simon Glass <s...@chromium.org> wrote: > This series is mainly designed to move the macb Ethernet to driver model, > along with the LCD controller. It also includes a few fixes: > > - NAND with ECC doesn't build properly > - The instruction cache is off by default > - Ethernet macb doesn't send packets when the cache is enabled > > A Snapper 9G45-based board is used for this work. It includes an AT91SAM9G45 > CPU so is a good test of driver model on this chip. > > > Simon Glass (18): > at91: Add support for the AT91 slow clock controller > arm: Allow skipping of low-level init with I-cache on > bootm: Align cache flush end address correctly > net: Handle an empty bootp extension section > net: macb: Prepare for driver-model conversion > net: macb: Flush correct cache portion when sending > net: macb: Convert to driver model > arm: at91: dts: Bring in device tree file for AT91SAM9G45 > arm: at91: Add a header file for the real-time clock > at91: Correct NAND ECC register access > at91: nand: Set up the ECC strength correctly > mtd: nand: Drop a blank line in nand_wait() > at91: Add driver-model GPIO devices for AT91SAM9G45 > at91: mtd: nand: Add dev_warn() to correct build error in driver > at91: video: Prepare for driver-model conversion > at91: video: Support driver-model for the LCD driver > fdt: Correct return value in fdtdec_decode_display_timing() > arm: at91: Add support for gurnard >
FYI I'm going to resend this series as the author is wrong in several commits. Sorry for the trouble. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
