Hello Eric, Eric Millbrandt wrote: > Reset any i2c devices that may have been interrupted during a system reset. > Normally this would be accomplished by clocking the line until SCL and SDA > are released and then sending a start condtiion (From an Atmel datasheet). > There is no direct access to the i2c pins so instead create start commands > through the i2c interface. Send a start command then delay for the SDA Hold > time, repeat this by disabling/enabling the bus a total of 9 times. > > Signed-off-by: Eric Millbrandt <emillbra...@dekaresearch.com> > --- > > changes since v1 > - Fixed compiler warning
Applied to u-boot-i2c.git Thanks for your work, bye Heiko -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot