From: Ye Li <ye...@nxp.com> The USDHC move the 4 clock bits CARD_CLK_SOFT_EN, IPG_PERCLK_SOFT_EN, HCLK_SOFT_EN, and IPG_CLK_SOFT_EN from sysctl register to vendorspec register. The driver uses RSTA to replace the clock gate off operation. But this is not a good solution. This is because: 1. when using RSTA, we should wait this bit to clear by itself. This is not implemeneted in the code. 2. After RSTA is set, it is recommended that the Host Driver reset the external card and reinitialize it.
So in this patch, we change to use the vendorspec registers for these bits operation. Signed-off-by: Ye Li <ye...@nxp.com> Signed-off-by: Peng Fan <van.free...@gmail.com> Cc: York Sun <york....@nxp.com> Cc: Stefano Babic <sba...@denx.de> Cc: Pantelis Antoniou <pa...@antoniou-consulting.com> Cc: Fabio Estevam <fabio.este...@nxp.com> --- V2: Rebased to latest U-Boot master drivers/mmc/fsl_esdhc.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c index 9cd582f..d3a18c0 100644 --- a/drivers/mmc/fsl_esdhc.c +++ b/drivers/mmc/fsl_esdhc.c @@ -538,7 +538,7 @@ static void set_sysctl(struct mmc *mmc, uint clock) clk = (pre_div << 8) | (div << 4); #ifdef CONFIG_FSL_USDHC - esdhc_setbits32(®s->sysctl, SYSCTL_RSTA); + esdhc_clrbits32(®s->vendorspec, VENDORSPEC_CKEN); #else esdhc_clrbits32(®s->sysctl, SYSCTL_CKEN); #endif @@ -548,7 +548,7 @@ static void set_sysctl(struct mmc *mmc, uint clock) udelay(10000); #ifdef CONFIG_FSL_USDHC - esdhc_clrbits32(®s->sysctl, SYSCTL_RSTA); + esdhc_setbits32(®s->vendorspec, VENDORSPEC_PEREN | VENDORSPEC_CKEN); #else esdhc_setbits32(®s->sysctl, SYSCTL_PEREN | SYSCTL_CKEN); #endif @@ -643,6 +643,8 @@ static int esdhc_init(struct mmc *mmc) #ifndef CONFIG_FSL_USDHC esdhc_setbits32(®s->sysctl, SYSCTL_HCKEN | SYSCTL_IPGEN); +#else + esdhc_setbits32(®s->vendorspec, VENDORSPEC_HCKEN | VENDORSPEC_IPGEN); #endif /* Set the initial clock speed */ @@ -740,6 +742,9 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv) #ifndef CONFIG_FSL_USDHC esdhc_setbits32(®s->sysctl, SYSCTL_PEREN | SYSCTL_HCKEN | SYSCTL_IPGEN | SYSCTL_CKEN); +#else + esdhc_setbits32(®s->vendorspec, VENDORSPEC_PEREN | + VENDORSPEC_HCKEN | VENDORSPEC_IPGEN | VENDORSPEC_CKEN); #endif writel(SDHCI_IRQ_EN_BITS, ®s->irqstaten); -- 2.6.2 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot