Trying to respond inline: On 06/17/2016 09:39 AM, Christian Didriksson wrote: > Hi Marek, > > I applied the two patches you suggested, but got no change in behavior: > > U-Boot SPL 2016.05-ga0bd0e7-dirty (Jun 17 2016 - 16:32:35) > drivers/ddr/altera/sequencer.c: Preparing to start memory calibration > drivers/ddr/altera/sequencer.c: CALIBRATION PASSED > drivers/ddr/altera/sequencer.c: Calibration complete > Trying to boot from SPI > >
I haven't tested on QSPI. I tested my patch on a board with SD/MMC. I'll check it on a QSPI board shortly. > U-Boot 2016.05-ga0bd0e7-dirty (Jun 17 2016 - 16:32:35 +0200) > > CPU: Altera SoCFPGA Platform > FPGA: Altera Cyclone V, SE/A6 or SX/C6 or ST/D6, version 0x0 > BOOT: QSPI Flash (1.8V) > Watchdog enabled > I2C: ready > DRAM: 1 GiB > > Best regards, > > Christian > >> On 06/16/2016 12:13 PM, Christian Didriksson wrote: >>> Hi! >> >> Hi, >> >>>> On 06/15/2016 12:06 PM, Christian Didriksson wrote: >>>>> Trying again. >>>> >>>> Hi! >>>> >>>>> I have reverted back to a vanilla u-boot-2016.05, added the >>>>> not-enter-quad-mode patch >>>> >>>> What's this patch ? Can you share it ? >> >> [...] >> >> Thanks >> >>> Some comments: >>> >>> We want to run ECC, but I don't think the SPL supports scrubbing etc. yet so >> I undefined those qts-parameters. Am I right regarding ECC for SDRAM? >> Yes, in order for ECC, you need to scrub the SDRAM. I'll look to see what is needed. Dinh _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot