Populating QSPI_RD_SNGL bit(0x1) in priv->cmd means that value
QSPI_INVAL (0x4) is not written to CMD field of QSPI_SPI_CMD_REG in
ti_qspi_cs_deactivate(). Therefore CS is never deactivated between
successive READ ID which results in sf probe to fail.
Fix this by not populating priv->cmd with QSPI_RD_SNGL and OR it wih
priv->cmd as required (similar to the convention followed in the
driver).
Signed-off-by: Vignesh R <vigne...@ti.com>
---
v2: fix up debug print
drivers/spi/ti_qspi.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
index 9a372ad31dae..a850aa26ec2b 100644
--- a/drivers/spi/ti_qspi.c
+++ b/drivers/spi/ti_qspi.c
@@ -247,13 +247,12 @@ static int __ti_qspi_xfer(struct ti_qspi_priv *priv,
unsigned int bitlen,
debug("tx done, status %08x\n", status);
}
if (rxp) {
- priv->cmd |= QSPI_RD_SNGL;
debug("rx cmd %08x dc %08x\n",
- priv->cmd, priv->dc);
+ ((u32)(priv->cmd | QSPI_RD_SNGL)), priv->dc);
#ifdef CONFIG_DRA7XX
udelay(500);
#endif
- writel(priv->cmd, &priv->base->cmd);
+ writel(priv->cmd | QSPI_RD_SNGL, &priv->base->cmd);
status = readl(&priv->base->status);
timeout = QSPI_TIMEOUT;
while ((status & QSPI_WC_BUSY) != QSPI_XFER_DONE) {
--
2.9.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
