Move back_to_bootrom() call later in SPL init so that the console is
initialized and printouts happen.
Currently when ROCKCHIP_SPL_BACK_TO_BROM is enabled there is no console
output from the SPL init stages.
I wasn't sure exactly where this should happen, so if we are set to do
run spl_board_init, then go back to bootrom there after
preloader_console_init(). Otherwise fall back to old behavior of doing
it in board_init_f.
Signed-off-by: Sandy Patterson <apatter...@sightlogix.com>
---
arch/arm/mach-rockchip/rk3288-board-spl.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/arch/arm/mach-rockchip/rk3288-board-spl.c
b/arch/arm/mach-rockchip/rk3288-board-spl.c
index e0d92a6..0c2d525 100644
--- a/arch/arm/mach-rockchip/rk3288-board-spl.c
+++ b/arch/arm/mach-rockchip/rk3288-board-spl.c
@@ -206,7 +206,7 @@ void board_init_f(ulong dummy)
debug("DRAM init failed: %d\n", ret);
return;
}
-#ifdef CONFIG_ROCKCHIP_SPL_BACK_TO_BROM
+#if defined(CONFIG_ROCKCHIP_SPL_BACK_TO_BROM) &&
!defined(CONFIG_SPL_BOARD_INIT)
back_to_bootrom();
#endif
}
@@ -273,6 +273,9 @@ void spl_board_init(void)
}
preloader_console_init();
+#ifdef CONFIG_ROCKCHIP_SPL_BACK_TO_BROM
+ back_to_bootrom();
+#endif
return;
err:
printf("spl_board_init: Error %d\n", ret);
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
