Hello Dirk, Dirk Behme wrote: > Heiko Schocher wrote: >> Hello Tom, >> >> Tom Rix wrote: >>> This changes fixes an early i2c error. >>> >>> It appears that I2C is working because once a read or write >>> error is detected, the omap24xx_i2c driver calls i2c_init >>> inside its error handling check. >>> >>> While it is ok to attempt error handling this way, the boards >>> must not depend on this side effect to initialize it's i2c. >>> >>> Instead of explicitly calling i2c_init for every board, use >>> the generic arm initialization in lib_arm/board.c. By defining >>> the config variable CONFIG_HARD_I2C, the omap3 i2c initialization >>> is included in the init_sequence table. >>> >>> Run tested on Beagle. >>> Compile tested on the omap3's >>> >>> Signed-off-by: Tom Rix <tom....@windriver.com> >>> --- >> >> Patch does not apply: > > It seems that it applies to u-boot-ti. Is it ok to move it through > u-boot-ti into mainline?
This is okay for me, so I just make: Acked-by: Heiko Schocher<h...@denx.de> bye Heiko -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot