On 31/10/2016 00:33, Eric Nelson wrote: > This set of patches updates the interface to the DDR calibration in > preparation for the addition of a pseudo-board for calibration on > i.MX6. > > The first patch fixes an ommission in the use of the DG_CMP_CYC flag > in register MPDGCTRL0. > > The second patch cleans up the handling of bus widths by passing > the system configuration information to the calibration routines. > > The third patch adds support for returning the calibration data > written to the MMDC registers. > > The fourth patch adds a Kconfig selection to inclut the DDR calibration > routines. > > Eric Nelson (4): > mx6: ddr: allow 32 cycles for DQS gating calibration > mx6: ddr: pass mx6_ddr_sysinfo to calibration routines > mx6: ddr: add routine to return DDR calibration data > ARM: mx6: ddr: use Kconfig for inclusion of DDR calibration routines > > arch/arm/cpu/armv7/mx6/Kconfig | 5 ++ > arch/arm/cpu/armv7/mx6/ddr.c | 131 > +++++++++++++++++++++----------- > arch/arm/include/asm/arch-mx6/mx6-ddr.h | 8 +- > board/kosagi/novena/novena_spl.c | 4 +- > configs/novena_defconfig | 1 + > 5 files changed, 100 insertions(+), 49 deletions(-) >
Applied to u-boot-imx, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot