Runtime U-boot dtb selection is generally a two step process. First step is to simply use an initial generic dtb. The second step is to select the dtb and perhaps execute additional code ones U-boot knows what board it is running on. Embedded_dtb_select handles the second step by allowing board specific code to run and perform what ever necessary configuration that is needed.
Signed-off-by: Franklin S Cooper Jr <fcoo...@ti.com> --- common/Kconfig | 10 ++++++++++ common/board_f.c | 3 +++ include/common.h | 4 ++++ 3 files changed, 17 insertions(+) diff --git a/common/Kconfig b/common/Kconfig index 2429953..b6327f0 100644 --- a/common/Kconfig +++ b/common/Kconfig @@ -421,6 +421,16 @@ config SYS_STDIO_DEREGISTER endmenu +config DTB_RESELECT + bool "Support swapping dtbs at a later point in boot" + depends on FIT_EMBED + default n + help + It is possible during initial boot you may need to use a generic + dtb until you can fully determine the board your running on. This + config allows boards to implement a function at a later point + during boot to switch to the "correct" dtb. + config FIT_EMBED bool "Support a FIT image embedded in the U-boot image" default n diff --git a/common/board_f.c b/common/board_f.c index a212f2b..b383239 100644 --- a/common/board_f.c +++ b/common/board_f.c @@ -759,6 +759,9 @@ static const init_fnc_t init_sequence_f[] = { #if defined(CONFIG_DISPLAY_CPUINFO) print_cpuinfo, /* display cpu info (and speed) */ #endif +#if defined(CONFIG_DTB_RESELECT) + embedded_dtb_select, +#endif #if defined(CONFIG_DISPLAY_BOARDINFO) show_board_info, #endif diff --git a/include/common.h b/include/common.h index 45f190a..ebc716e 100644 --- a/include/common.h +++ b/include/common.h @@ -478,6 +478,10 @@ void pci_init_board(void); #endif #endif +#if defined(CONFIG_DTB_RESELECT) +int embedded_dtb_select(void); +#endif + int misc_init_f (void); int misc_init_r (void); -- 2.10.0 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot