Hi Ken, On 22.06.2017 11:13, m...@marvell.com wrote: > From: Ken Ma <m...@marvell.com> > > If north bridge selection register bit1 is clear, pins [10:8] are for > SDIO0 Resetn, Wakeup, and PDN while if bit1 is set, pins [10:8]are for > GPIO; when bit1 is clear, pin 9 and pin 10 can be used for uart2 RTSn > and CTSn, so bit1 should be added to uart2 group and it must be set > for both "gpio" and "uart" functions of uart2 group. > > Signed-off-by: Ken Ma <m...@marvell.com> > Cc: Stefan Roese <s...@denx.de> > Cc: Kostya Porotchkin <kos...@marvell.com> > Cc: Gregory CLEMENT <gregory.clem...@free-electrons.com> > Cc: Nadav Haklai <nad...@marvell.com> > Cc: Wilson Ding <ding...@marvell.com>
Thanks for the the patches. One remark though about the patch submission process: You should mark version of your patches and list the changes (patch history) in the patch as described here: http://www.denx.de/wiki/view/U-Boot/Patches#Sending_updated_patch_versions This makes the review process much easier, as the reviewer does not need to review the whole patch again, but only need to look for the new changes in new version. You don't need to do it for these patches, but please do it the next time. For this patch: Reviewed-by: Stefan Roese <s...@denx.de> Thanks, Stefan _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
