On Sun, 22 Nov 2009 22:17 +0100, Wolfgang Denk wrote : > Dear Albin Tonnerre, > > In message > <1252442374-25386-1-git-send-email-albin.tonne...@free-electrons.com> you > wrote: > > This patch allows to use the atmel_mci SD/MMC driver on the at91 > > architecture. > > It contains: > > - initialization code for the MCI controller for all the supported AT91. It > > allows the use of only one controller even if a SoC has two controllers > > (anyway there's no support for it in atmel_mci as of now) > > - the necessary get_mci_clk_rate function > > - definition of MMCI_BASE for use in atmel_mci > > - the cpu_mmc_init function. As of now this is not used, but will be > > required > > when atmel_mci is ported to the new generic mmc API. > > > > Signed-off-by: Albin Tonnerre <albin.tonne...@free-electrons.com> > > Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagn...@jcrosoft.com> > > --- > > Changes since v1 > > - Fix the MCI controller ID in the init code for CAP9, SAM9263 and SAM9G45 > > - Move AT91_BASE_MCI* define to soc header > > - define AT91_BASE_MCI{0,1} instead of AT91_BASE_MCI for boards which have > > 2 > > controllers > > - rework the way MMCI_BASE is defined accordingly > > > > Changes since v2 > > - allow using 8-bit bus width on CPUs that support it > > - change the arguments of atmel_mciX_hw_init to (slot, bus) so that it's > > more > > meaningful than (bitmask) > > What's the current state of this patch? Do you consider it ripe for > inclusion into mainline, or do you still have changes pending?
I consider it ready for inclusion. Thanks for the heads-up. Regards, -- Albin Tonnerre, Free Electrons Kernel, drivers and embedded Linux development, consulting, training and support. http://free-electrons.com _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot