On 18.01.2018 09:23, Michael Nazzareno Trimarchi wrote:
Hi
On Thu, Jan 18, 2018 at 9:15 AM, Simon Goldschmidt
<sgoldschm...@de.pepperl-fuchs.com> wrote:
When the device tree is missing a correct spi slave description below
the bus, the 'set_speed' callback can be called with 'speed' == 0 Hz.
At least with cadence qspi, this leads to a division by zero.
Prevent this by initializing speed to 100 kHz in this case, as is
done in 'dm_spi_claim_bus'.
Signed-off-by: Simon Goldschmidt <sgoldschm...@de.pepperl-fuchs.com>
---
drivers/spi/spi-uclass.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/spi/spi-uclass.c b/drivers/spi/spi-uclass.c
index e06a603ab1..41ecef77db 100644
--- a/drivers/spi/spi-uclass.c
+++ b/drivers/spi/spi-uclass.c
@@ -325,6 +325,8 @@ int spi_get_bus_and_cs(int busnum, int cs, int speed, int
mode,
if (!speed) {
speed = plat->max_hz;
mode = plat->mode;
+ if (!speed)
+ speed = 100000;
You should add a warming message
Hmm, I just copied what 'dm_spi_claim_bus' does some hundred lines above
in the same file. Why should one code path warn when the other doesn't?
Simon
Michael
}
ret = spi_set_speed_mode(bus, speed, mode);
if (ret)
--
2.11.0
<snip>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot