On 01/11/2018 12:28, Marek Vasut wrote: > On 01/11/2018 08:19 AM, Goldschmidt Simon wrote: >> This driver has been using printf() including filename since it was >> added. Convert to using debug() instead. >> >> Signed-off-by: Simon Goldschmidt <sgoldschm...@de.pepperl-fuchs.com> > > Applied, thanks.
I can't see this one in u-boot-socfpga. Anything wrong here? Regards, Simon >> --- >> >> drivers/ddr/altera/sequencer.c | 8 ++++---- >> 1 file changed, 4 insertions(+), 4 deletions(-) >> >> diff --git a/drivers/ddr/altera/sequencer.c b/drivers/ddr/altera/sequencer.c >> index 6c6bd90e94..42e87b50d3 100644 >> --- a/drivers/ddr/altera/sequencer.c >> +++ b/drivers/ddr/altera/sequencer.c >> @@ -3534,7 +3534,7 @@ static void debug_mem_calibrate(int pass) >> u32 debug_info; >> >> if (pass) { >> - printf("%s: CALIBRATION PASSED\n", __FILE__); >> + debug("%s: CALIBRATION PASSED\n", __FILE__); >> >> gbl->fom_in /= 2; >> gbl->fom_out /= 2; >> @@ -3553,7 +3553,7 @@ static void debug_mem_calibrate(int pass) >> writel(debug_info, &phy_mgr_cfg->cal_debug_info); >> writel(PHY_MGR_CAL_SUCCESS, &phy_mgr_cfg->cal_status); >> } else { >> - printf("%s: CALIBRATION FAILED\n", __FILE__); >> + debug("%s: CALIBRATION FAILED\n", __FILE__); <> >> debug_info = gbl->error_stage; >> debug_info |= gbl->error_substage << 8; >> @@ -3570,7 +3570,7 @@ static void debug_mem_calibrate(int pass) >> writel(debug_info, &sdr_reg_file->failing_stage); >> } >> >> - printf("%s: Calibration complete\n", __FILE__); >> + debug("%s: Calibration complete\n", __FILE__); >> } >> >> /** >> @@ -3741,7 +3741,7 @@ int sdram_calibration_full(void) >> >> initialize_tracking(); >> >> - printf("%s: Preparing to start memory calibration\n", __FILE__); >> + debug("%s: Preparing to start memory calibration\n", __FILE__); >> >> debug("%s:%d\n", __func__, __LINE__); >> debug_cond(DLEVEL >= 1, >> > > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot