On 04/18/2018 09:02 AM, Jorge Ramirez-Ortiz wrote:
On 04/17/2018 02:01 PM, Ramon Fried wrote:
The clock node is used by the serial driver and it's needed
before relocation.
This patch ensures that the msm-serial driver can actually
use the clock node.
Signed-off-by: Ramon Fried <ramon.fr...@linaro.org>
---
arch/arm/dts/dragonboard410c.dts | 2 ++
1 file changed, 2 insertions(+)
diff --git a/arch/arm/dts/dragonboard410c.dts
b/arch/arm/dts/dragonboard410c.dts
index 5ccfe7f8c8..f37ef5d523 100644
--- a/arch/arm/dts/dragonboard410c.dts
+++ b/arch/arm/dts/dragonboard410c.dts
@@ -38,12 +38,14 @@
#size-cells = <0x1>;
ranges = <0x0 0x0 0x0 0xffffffff>;
compatible = "simple-bus";
+ u-boot,dm-pre-reloc;
I think the intent is to make dm-pre-reloc legacy.
New platforms should be using "u-boot,dm-spl" even if CONFIG_SPL_BUILD
is not enabled (I believe it should work)
clkc: qcom,gcc@1800000 {
compatible = "qcom,gcc-apq8016";
reg = <0x1800000 0x80000>;
#address-cells = <0x1>;
#size-cells = <0x0>;
+ u-boot,dm-pre-reloc;
};
serial@78b0000 {
another question is, how will you probe the clock driver before the uart?
I think even if you probed in misc_init_f it is already too late.
other than that - + Peter Robinson's comments- looks good.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot