Hi, Le 20/02/2010 08:25, Maxim Podbereznyi a écrit : > OK, then can you explain what software do you flash? Does rm9200 u-boot > setup PLL? Because if it is not then you will never see anything at DBGU > pins. Another problem can be with your RC filters for PLL. Did you use the > same quartz as in the Atmel design? If not then you must calculate RC > filters and change them on your board. > > BTW, if your SDRAM does not work then u-boot will never start :) > > 2010/2/19 Nikumbh, Raj (IE10)<raj.niku...@honeywell.com> > >> Yeah I did pull it down at the startup. And I meant the same DBGU pins. >> the board support in board/eukrea/cpuat91 was working fine last time I tested it and this board is close to your configuration (AT91RM9200 + NOR Flash 16bits width) so maybe you can try it (you may just need to update SDRAM geometry and timings and SMC timings for your NOR flash).
Eric _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
