On Wed, 11 Jul 2018 17:25:29 +0200 Miquel Raynal <miquel.ray...@bootlin.com> wrote:
> From: Boris Brezillon <boris.brezil...@bootlin.com> > > Add bindings for SPI NAND chips. > > Signed-off-by: Boris Brezillon <boris.brezil...@bootlin.com> > Signed-off-by: Miquel Raynal <miquel.ray...@bootlin.com> > --- > doc/device-tree-bindings/mtd/spi-nand.txt | 27 +++++++++++++++++++++++++++ > 1 file changed, 27 insertions(+) > create mode 100644 doc/device-tree-bindings/mtd/spi-nand.txt > > diff --git a/doc/device-tree-bindings/mtd/spi-nand.txt > b/doc/device-tree-bindings/mtd/spi-nand.txt > new file mode 100644 > index 0000000000..d55f80196c > --- /dev/null > +++ b/doc/device-tree-bindings/mtd/spi-nand.txt > @@ -0,0 +1,27 @@ > +SPI NAND flash > + > +Required properties: > +- compatible: should be "spi-nand" > +- reg: should encode the chip-select line used to access the NAND chip > + > +Optional properties > +- spi-max-frequency: maximum frequency of the SPI bus the chip can operate > at. > + This should encode board limitations (i.e. max freq can't > + be achieved due to crosstalk on IO lines). > + When unspecified, the driver assumes the chip can run at > + the max frequency defined in the spec (information > + extracted chip detection time). > +- spi-tx-bus-width: The bus width (number of data wires) that is used for > MOSI. > + Only encodes the board constraints (i.e. when not all IO > + signals are routed on the board). Device constraints are > + extracted when detecting the chip, and controller > + constraints are exposed by the SPI mem controller. If this > + property is missing that means no constraint at the board > + level. > +- spi-rx-bus-width: The bus width (number of data wires) that is used for > MISO. > + Only encodes the board constraints (i.e. when not all IO > + signals are routed on the board). Device constraints are > + extracted when detecting the chip, and controller > + constraints are exposed by the SPI mem controller. If this > + property is missing that means no constraint at the board > + level. This section has been dropped from the Linux doc. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot