This patch adds a call to spl_early_init() to board_init_f() which is
needed when CONFIG_SPL_OF_CONTROL is configured. This is necessary for
the early SPL setup including the DTB setup for later usage.
Please note that this call might also be needed for non SPL_OF_CONTROL
board, like the smartweb target. But smartweb fails to build with this
call because its binary grows too big. So I disabled it for these kind
of targets for now.
Signed-off-by: Stefan Roese <s...@denx.de>
Cc: Heiko Schocher <h...@denx.de>
Cc: Andreas Bießmann <andr...@biessmann.org>
Cc: Eugen Hristev <eugen.hris...@microchip.com>
---
arch/arm/mach-at91/spl_at91.c | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/arch/arm/mach-at91/spl_at91.c b/arch/arm/mach-at91/spl_at91.c
index 23ebaa99b1..1065f090e0 100644
--- a/arch/arm/mach-at91/spl_at91.c
+++ b/arch/arm/mach-at91/spl_at91.c
@@ -75,6 +75,16 @@ void __weak spl_board_init(void)
void board_init_f(ulong dummy)
{
+#if CONFIG_IS_ENABLED(OF_CONTROL)
+ int ret;
+
+ ret = spl_early_init();
+ if (ret) {
+ debug("spl_early_init() failed: %d\n", ret);
+ hang();
+ }
+#endif
+
lowlevel_clock_init();
#if !defined(CONFIG_WDT_AT91)
at91_disable_wdt();
--
2.21.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
