Hi,
I am trying to use a X850 V1.3 hat (USB/mSATA) for Raspberry Pi 3:
http://www.raspberrypiwiki.com/index.php/X850#Installation_Guide_For_X850_V1.3_Old_Version
It works to load firmware (most of the time), but it fails in u-boot with:
starting USB...
USB0: scanning bus 0 for devices... usb_new_device: Cannot read
configuration, skipping device 152d:0578
or just fails to find it (after a long timeout):
USB0: scanning bus 0 for devices... 4 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
Only once I got it detected:
starting USB...
USB0: scanning bus 0 for devices... 4 USB Device(s) found
scanning usb for storage devices... 1 Storage Device(s) found
Hit any key to stop autoboot: 0
(snip)
Device 0: Vendor: JMicron Rev: 0204 Prod: Generic
Type: Hard Disk
Capacity: 238475.1 MB = 232.8 GB (488397168 x 512)
... is now current device
But then, the loaded EFI payload seems to be corrupted (bad read?).
Please note it is working fine when connected to a Linux PC host, without
external 5V.
Cheers,
Guillaume
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
