On 4/1/19 2:46 PM, Neil Armstrong wrote: > Adds support for Amlogic G12A USB Control Glue HW. > > The Amlogic G12A SoC Family embeds 2 USB Controllers : > - a DWC3 IP configured as Host for USB2 and USB3 > - a DWC2 IP configured as Peripheral USB2 Only > > A glue connects these both controllers to 2 USB2 PHYs, and optionnally > to an USB3+PCIE Combo PHY shared with the PCIE controller. > > The Glue configures the UTMI 8bit interfaces for the USB2 PHYs, including > routing of the OTG PHY between the DWC3 and DWC2 controllers, and > setups the on-chip OTG mode selection for this PHY. > > This driver sets the OTG capable port as Host mode by default, > the switch to Device mode is to be done in a separate patch. > > Signed-off-by: Neil Armstrong <narmstr...@baylibre.com>
Reviewed-by: Marek Vasut <ma...@denx.de> -- Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot