On Fri, Apr 05, 2019 at 12:10:21PM +0200, Wadim Egorov wrote: > Hi, > > it seems the new common rockchip pinctrl driver does not really fit into > our phycore-rk3288 SPL setup. It works for every other rk3288 based > board because they don't need special power configurations at the SPL stage.
It turns out tinker-rk3288 SPL no longer fits in 2019.04 and previously worked fine in 2019.01. Warning: SPL image is too large (size 0x8800) and will not boot Error: image verification failed built with gcc-linaro 6.3.2017.02 bisecting led to the pinctrl changes. with SPL_PINCTRL_ROCKCHIP disabled it fits and U-Boot output on serial gets as far as the efi loader then no output appears on serial when a kernel is loaded. > > So my question is: is there any work going on to reduce the SPL size > even more? > > Besides that, I think I can remove the power stuff at the SPL stage from > our board. The SOM was redesigned and is equipped with an STM8 connected > to the RK818. The required setup we did before in the SPL is now done by > the ST controller. I know there are only a few SOMs without the STM8 out > in the wild. So if I remove it it will affect only a few people who > probably already have both boards. > > Regards, > Wadim > > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > https://lists.denx.de/listinfo/u-boot _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot