This addresses the following warning message: ===================== WARNING ====================== This board does not use CONFIG_DM_USB. Please update the board to use CONFIG_DM_USB before the v2019.07 release. Failure to update by the deadline may result in board removal. See doc/driver-model/MIGRATION.txt for more info. ====================================================
As USB support for older OMAP3 SoC's improves, OMAP3 EVM can be readily adapted. There is some additional 'gpio-hog' support needed to fully setup USB in a similar manner to Linux. Signed-off-by: Derald D. Woods <woods.techni...@gmail.com> --- board/ti/evm/evm.c | 31 ------------------------------- configs/omap3_evm_defconfig | 3 +++ include/configs/omap3_evm.h | 2 -- 3 files changed, 3 insertions(+), 33 deletions(-) diff --git a/board/ti/evm/evm.c b/board/ti/evm/evm.c index daecb4af3e..93408047b2 100644 --- a/board/ti/evm/evm.c +++ b/board/ti/evm/evm.c @@ -30,11 +30,6 @@ #include <linux/usb/musb.h> #include "evm.h" -#ifdef CONFIG_USB_EHCI_HCD -#include <usb.h> -#include <asm/ehci-omap.h> -#endif - #define OMAP3EVM_GPIO_ETH_RST_GEN1 64 #define OMAP3EVM_GPIO_ETH_RST_GEN2 7 @@ -307,32 +302,6 @@ void board_mmc_power_init(void) } #endif /* CONFIG_MMC */ -#if defined(CONFIG_USB_EHCI_HCD) && !defined(CONFIG_SPL_BUILD) -/* Call usb_stop() before starting the kernel */ -void show_boot_progress(int val) -{ - if (val == BOOTSTAGE_ID_RUN_OS) - usb_stop(); -} - -static struct omap_usbhs_board_data usbhs_bdata = { - .port_mode[0] = OMAP_USBHS_PORT_MODE_UNUSED, - .port_mode[1] = OMAP_EHCI_PORT_MODE_PHY, - .port_mode[2] = OMAP_USBHS_PORT_MODE_UNUSED -}; - -int ehci_hcd_init(int index, enum usb_init_type init, - struct ehci_hccr **hccr, struct ehci_hcor **hcor) -{ - return omap_ehci_hcd_init(index, &usbhs_bdata, hccr, hcor); -} - -int ehci_hcd_stop(int index) -{ - return omap_ehci_hcd_stop(); -} -#endif /* CONFIG_USB_EHCI_HCD */ - #if defined(CONFIG_USB_ETHER) && defined(CONFIG_USB_MUSB_GADGET) && !defined(CONFIG_CMD_NET) int board_eth_init(bd_t *bis) { diff --git a/configs/omap3_evm_defconfig b/configs/omap3_evm_defconfig index a3b662db2b..26d0e65589 100644 --- a/configs/omap3_evm_defconfig +++ b/configs/omap3_evm_defconfig @@ -66,7 +66,10 @@ CONFIG_SPI=y CONFIG_DM_SPI=y CONFIG_OMAP3_SPI=y CONFIG_USB=y +CONFIG_DM_USB=y +# CONFIG_SPL_DM_USB is not set CONFIG_USB_EHCI_HCD=y +CONFIG_USB_OMAP3=y CONFIG_USB_MUSB_GADGET=y CONFIG_USB_MUSB_OMAP2PLUS=y CONFIG_USB_GADGET=y diff --git a/include/configs/omap3_evm.h b/include/configs/omap3_evm.h index 5b9d8a57e3..082a4edb2b 100644 --- a/include/configs/omap3_evm.h +++ b/include/configs/omap3_evm.h @@ -56,8 +56,6 @@ /* Environment */ #define CONFIG_ENV_SIZE SZ_128K -#define CONFIG_PREBOOT "usb start" - #define MEM_LAYOUT_ENV_SETTINGS \ DEFAULT_LINUX_BOOT_ENV -- 2.21.0 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot