On 25/06/2019 17:53, Marek Vasut wrote:
On 6/25/19 4:13 PM, Jean-Jacques Hiblot wrote:
Hi Marek,
On 06/02/2019 14:11, Marek Vasut wrote:
When using CMD6 to switch eMMC card timing from HS200/HS400 to HS/legacy,
do not poll for the completion status using CMD13, but rather wait 50mS.
Once the card receives the CMD6 and starts executing it, the bus is in
undefined state until both the card finishes executing the command and
until the controller switches the bus to matching timing configuration.
During this time, it is not possible to transport any commands or data
across the bus, which includes the CMD13.
Is it something that affects all platforms ?
I've been working on this on TI platforms lately and although I've seen
the same kind of problems. But they mostly go away If the code handling
the switch handles the SWITCH_ERROR bit.
The error probably happens because you send the card a command, but the
command hits the bus that's in some weird intermediate state. Either the
card didn't finish switching the bus properties yet, or it did, or it's
in the middle of it, but you cannot tell.
OK thanks for the response.
If CMD13 can't be used because the bus is in an undefined state,
shouldn't send_cmd(CMD13) just fail ?
I'm asking because this is a 50ms delay in the hot path of the boot
process.
JJ
[...]
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
