On 6/4/19 9:06 AM, Vagrant Cascadian wrote: > On 2019-05-17, Marek Vasut wrote: >> Update Kosagi Novena to DM / DT and remove the warnings. >> This depends on the following patches / series: >> >> https://patchwork.ozlabs.org/patch/1095618/ >> https://patchwork.ozlabs.org/patch/1101171/ > > These are now merged in 2019.07-rc3. > >> https://patchwork.ozlabs.org/project/uboot/list/?series=108463 > > These were not yet. > > I have two oustanding issues... with some files it sometimes fails to > load one or more from SATA: > > Retrieving file: /boot/initrd.img-5.0.0-trunk-armmp > 20077960 bytes read in 375 ms (51.1 MiB/s) > Retrieving file: /boot/vmlinuz-5.0.0-trunk-armmp > 4215296 bytes read in 40 ms (100.5 MiB/s) > append: root=UUID=9666ab0b-f932-4e2f-95d7-0e96a12a4540 ro quiet > Retrieving file: /usr/lib/linux-image-5.0.0-trunk-armmp/imx6q-novena.dtb > CACHE: Misaligned operation at range [fafb5398, fafb6398] > CACHE: Misaligned operation at range [fafb5398, fafb6398] > ERROR: v7_outer_cache_inval_range - start address is not aligned - > 0xfafb5398 > ERROR: v7_outer_cache_inval_range - stop address is not aligned - > 0xfafb6398 > invalid extent block > > It then falls back to one of the other kernels (using the extlinux.conf > parsing) and succeeds. It consistantly gets a cache/alignment error with > this specific file. A bit-for-bit identical .dtb loaded from another > path works just fine. Older versions of u-boot boot this fine. Would > some particular EXT4 flag possibly be causing issues?
I don't know. Do you still run into this with u-boot/master ? > Several other kernel+initrd+dtb combinations work fine. > > I have not noticed issues loading from PXE. > > > The second issue is still using one out of four exposed USB ports fails > and resets the board: > > load usb 0:1 $kernel_addr_r misc/Binaries/linux/Image > data abort > pc : [<fefbb67a>] lr : [<fefbb0fd>] > reloc pc : [<1783367a>] lr : [<178330fd>] > sp : faf7c6e8 ip : 00000003 fp : 00000005 > r10: faf8b200 r9 : faf87ea0 r8 : 00000001 > r7 : faf8b2c0 r6 : f9f7a040 r5 : faf7c710 r4 : 00000038 > r3 : 0000006d r2 : f9f7a0a3 r1 : faf8b32c r0 : f9f7a09f > Flags: nzCv IRQs off FIQs off Mode SVC_32 > Code: 4630fc5b 81f0e8bd e7d84606 bf082b2f (f822235c) > Resetting CPU ... > > The three other usb ports work just fine with the same USB stick and > file. All four ports work with 2019.01. Can you debug it ? I think some of this was due to the EFI stuff , which I think was fixed since. Can you re-check that ? _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot