Dear Kim, On 23.06.2010 04:17, Kim Phillips wrote: >> +#define CONFIG_SYS_HID0_FINAL (HID0_ENABLE_MACHINE_CHECK | \ >> + HID0_ENABLE_DYNAMIC_POWER_MANAGMENT) >> > | HID0_ENABLE_INSTRUCTION_CACHE? >
I've enabled icache and now the board sometimes resets twice after U-Boot 'reset' command: => re Resetting the board. U-Boot 2010.06-rc3-00020-g093a164 (Jun 24 2010 - 17:45:17) MPC83XX Reset Status: Software Hard, External/Internal Soft, External/Internal Hard CPU: e300c3, MPC8308, Rev: 1.0 at 400 MHz, CSB: 133.333 MHz Board: Freescale MPC8308ERDB Rev 1.0 I2C: ready DRAM: U-Boot 2010.06-rc3-00020-g093a164 (Jun 24 2010 - 17:45:17) MPC83XX Reset Status: External/Internal Soft, External/Internal Hard CPU: e300c3, MPC8308, Rev: 1.0 at 400 MHz, CSB: 133.333 MHz Board: Freescale MPC8308ERDB Rev 1.0 I2C: ready DRAM: 128 MiB FLASH: 8 MiB PCIE0: link In: serial Out: serial Err: serial Net: eTSEC1: No support for PHY id ffffffff; assuming generic eTSEC0, eTSEC1 Hit any key to stop autoboot: 0 => (It doesn't always stop at "DRAM:" line but that position is most frequent) Maybe you have some ideas on this subject? Regards, Ilya. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot