> -----Original Message----- > From: Wolfgang Denk [mailto:w...@denx.de] > Sent: Monday, June 28, 2010 5:32 PM > To: Tor Krill > Cc: Prafulla Wadaskar; u-boot@lists.denx.de > Subject: Re: [U-Boot] [PATCH V2] Allow PHY addresses on > kirkwood egiga to be non continuous. > > Dear Tor Krill, > > In message <1277716302.2221.37.ca...@tor-desktop> you wrote: > > > > > 2. For the boards using single port will also need to > configure PHY address > > > for other port, which is meaningless, unnecessary and confusing. > > > > Sure you had to put something there to be on the safe side. > But is that > > really that confusing, the SOC really have two ports, them > being used or > > not? > > It is indeed confusing and should be avoided if one has to configurwe > hardware ports that are not actually present or used on a specific > board. > > If needed, provide sane defaults internally in the code. > > But keep in mind that U-Boot requires that only used peripherals > should be initialized - we should not initisalize any unused ports.
Yes, This is already taken care by kirkwood_egiga driver, it only initialize selected port Regards.. Prafulla . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot