hi I am trying to use the board "dht-walnut", and I get this on the attempt to tftpboot
PHY speed read failed, assuming 10bT PHY duplex read failed, assuming half-duplex Using ppc_4xx_eth0 device The ppc405GP board is connected to a router whose ethernet port is rated 100bT/full-duplex, but on the dht-walnut side, the link only works at 200Kbyte/s rather than at higher bitrate. I am using uboot-v1.2, which is old, but it has a special "patch" only released for the dht-walnut support the feature "disk-boot" (bootstrap from the first pATA hard disk). Let me know if the problem with the ppc_4xx_eth0 device not properly configured for 100bT/full-duplex has been yet fixed. regards _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot