Hi I am using a Raspberry PI compute module (CM 3+), which seems to be running U-Boot - U-Boot 2019.04-dirty (Aug 21 2019 - 14:41:54 +0000)
The CM3+ is communicating on the UART at boot, before the Kernel loads: U-Boot 2019.04-dirty (Aug 21 2019 - 14:41:54 +0000) DRAM: 948 MiB RPI Compute Module 3 (0xa220a0) MMC: mmc@7e202000: 0, sdhci@7e300000: 1 Loading Environment from FAT... WARNING at drivers/mmc/bcm2835_sdhost.c:408/bcm2835_send_command()! WARNING at drivers/mmc/bcm2835_sdhost.c:408/bcm2835_send_OK In: serial Out: serial 1 0 WARNING at drivers/mmc/bcm2835_sdhost.c:408/bcm2835_send_command()! WARNING at drivers/mmc/bcm2835_sdhost.c:408/bcm2835_send_command()! switch to partitions #0, OK mmc0(part 0) is current device LOADBOOTENV Running uenvcmd ... ENVCMD 6697472 bytes read in 285 ms (22.4 MiB/s) 3647066 bytes read in 155 ms (22.4 MiB/s) 42064 bytes read in 12 ms (3.3 MiB/s) Kernel image @ 0x200000 [ 0x000000 - 0x663200 ] ## Flattened Device Tree blob at 02000000 Booting using the fdt blob at OK Loa Starting kern I however have a serial device connected to the UART and it starts communicating on power on to the UART. This is causing the boot process to stop. I would like to find out how to stop U-BOOT from reading messages on the UART at boot? Regards Lee Annamalai _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot