Hi Albert, Thanks for your reply. I compiled U-boot with the patch that enables support for OpenRD_client and OpenRD_ultimate given by Tanmay. OpenRD Client is connected to PC/Host with FTDI programmed for Channel A as CPU FIFO.
I'm using the binary for OpenOCD that I got from Marvell to tranfer uboot.bin into board's NAND. I copied the 'u-boot-2010.06.bin' in to ~\openocd\openocd.binaries.libftdi/bin as 'uboot.bin'. Then executed the command ' ./openocd –f target/board/openrd.cfg –c init -c openrd_reflash_uboot' Logs show: wrote file uboot.bin to NAND flash 0 up to offset 0x0004e800 in 50.190395s Info : JTAG tap: feroceon.cpu tap/device found: 0x20a023d3 (Manufacturer: 0x1e9, Part: 0x0a02, Version: 0x2) Info : JTAG Tap/device matched But then the board doesn't boot and the console is all blank :( Please let me know if I'm doing something wrong.. Thanks, Kalyan. Hi Kalyan, I've successfully used the base config for a client board, as well as used a patch recently sent to this list that adds client and ultimate support. You can search the list for 'ultimate' for instance: http://lists.denx.de/mailman/listinfo/u-boot Re: your issue, can you detail exactly how you load and run u-boot via openocd? What operations do you perform on the board, and what commands do you issue on your debugging host to launch openocd? Amicalement, -- Albert. On Thu, Jul 1, 2010 at 9:44 AM, kalyan karnati <kriskalya...@gmail.com>wrote: > Hello, > > I'm trying to build uboot.bin for Marvell OpenRD client from uboot-2010-06 > source file. > I noticed that there is no config file for OpenRD_client. So I compiled > openrd_base and sent the binary to the board using OpenOCD. But the board > doesn't even boot. > Can you please let me know if there is another board config specific to > OpenRD_Client or am I missing something ?? > > Thanks for you help, > > Best Regards, > Kalyan. >
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
