Dear Aaron, In message <2710076.TiSPtmOvtb@flash> you wrote: > > > What exactly do you need this for? Why don't you just link your > > code with the rest of U-Boot? > > We need it to obtain and modify the phy parameters. This is a custom 25G > gearbox that needs a lot of hand holding. This may end up being a low > priority > (not the gearbox, but the API). It's only a few hundred lines of code (the > API).
Again you don't answer my question. Why do you need a special new API for such code? Why do you not just link that code with the rest of U-Boot? It has been mentioned before, but just to be sure: this code which uses your new API is licensed under a GPLv2 conforming lincense? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de If you believe that feeling bad or worrying long enough will change a past or future event, then you are residing on another planet with a different reality system. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot