> Subject: [PATCH] imx8m: ddr_init: Move ddr_init() messages to debug level
>
> Currently inside ddr_init() there is a mix of printf() and debug() level
> messages.
>
> Since this type of information is useful for debug purposes, convert all of
> them
> to debug level for consistency.
>
> Signed-off-by: Fabio Estevam <feste...@gmail.com>
Reviewed-by: Peng Fan <peng....@nxp.com>
> ---
> drivers/ddr/imx/imx8m/ddr_init.c | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/ddr/imx/imx8m/ddr_init.c
> b/drivers/ddr/imx/imx8m/ddr_init.c
> index d6e915c9b9..21af66e4e7 100644
> --- a/drivers/ddr/imx/imx8m/ddr_init.c
> +++ b/drivers/ddr/imx/imx8m/ddr_init.c
> @@ -24,7 +24,7 @@ void ddr_init(struct dram_timing_info *dram_timing) {
> unsigned int tmp, initial_drate, target_freq;
>
> - printf("DDRINFO: start DRAM init\n");
> + debug("DDRINFO: start DRAM init\n");
>
> /* Step1: Follow the power up procedure */
> if (is_imx8mq()) {
> @@ -109,7 +109,7 @@ void ddr_init(struct dram_timing_info *dram_timing)
> tmp = reg32_read(DDRPHY_CalBusy(0));
> } while ((tmp & 0x1));
>
> - printf("DDRINFO:ddrphy calibration done\n");
> + debug("DDRINFO:ddrphy calibration done\n");
>
> /* Step15: Set SWCTL.sw_done to 0 */
> reg32_write(DDRC_SWCTL(0), 0x00000000); @@ -161,7 +161,7 @@
> void ddr_init(struct dram_timing_info *dram_timing)
>
> /* enable port 0 */
> reg32_write(DDRC_PCTRL_0(0), 0x00000001);
> - printf("DDRINFO: ddrmix config done\n");
> + debug("DDRINFO: ddrmix config done\n");
>
> /* save the dram timing config into memory */
> dram_config_save(dram_timing,
> CONFIG_SAVED_DRAM_TIMING_BASE);
> --
> 2.17.1
