> Subject: RE: [PATCH] imx: imx8qxp_mek: update README > > > Subject: Re: [PATCH] imx: imx8qxp_mek: update README > > > > Hi Peng > > > > On Tue, Jan 7, 2020 at 10:33 PM Peng Fan <peng....@nxp.com> wrote: > > > > > > Update README to use 4.19.35_1.1.0 released firmware images. > > > > I have tried the same here and I still get a hang with Ethernet. If I > > manually remove Ethernet support from the defconfig then I am able to > > get into the U-Boot prompt. > > > > Could you please share your U-Boot logs? > > I not have a board at hand. Will paste the log tomorrow.
The ipg clk patch needs to be reverted for now. Anyway the log as below: U-Boot SPL 2020.01-00025-gedb89b239c-dirty (Jan 08 2020 - 09:50:22 +0800) Normal Boot WDT: Not found! Trying to boot from MMC2_2 Load image from MMC/SD 0x46800 U-Boot 2020.01-00025-gedb89b239c-dirty (Jan 08 2020 - 09:50:22 +0800) CPU: NXP i.MX8QXP RevB A35 at 1200 MHz at 19C Model: Freescale i.MX8QXP MEK Board: iMX8QXP MEK Build: SCFW 550f3079, SECO-FW d7523fe8, ATF f900faa Boot: SD1 DRAM: 3 GiB Failed to enable ipg clk MMC: FSL_SDHC: 0, FSL_SDHC: 1 Loading Environment from MMC... *** Warning - bad CRC, using default environment In: serial@5a060000 Out: serial@5a060000 Err: serial@5a060000 Net: Failed to enable ipg clk Warning: ethernet@5b040000 using MAC address from ROM eth0: ethernet@5b040000 Hit any key to stop autoboot: 0 => Regards, Peng. > > Thanks, > Peng. > > > > > I use a i.MX8QXP mek with B0 silicon and revC1. > > > > Thanks