Hi Baruch,
Thanks for your comments. My replay below.
On 4/2/20 10:41, Baruch Siach wrote:
Hi Walter,
Thanks for the patch.
One comment below.
On Wed, Jan 29, 2020 at 10:58:07AM -0300, Walter Lozano wrote:
Make an additional step to add full DM support to mx6cuboxi, including its
support for SPL
With this new configuration SPL image is 50 KB, higher than the
38 KB from the previous version, but it still under the 68 KB limit.
Signed-off-by: Walter Lozano <walter.loz...@collabora.com>
---
arch/arm/dts/imx6qdl-hummingboard2-emmc-som-v15-u-boot.dtsi | 4 ++++
configs/mx6cuboxi_defconfig | 3 +++
2 files changed, 7 insertions(+)
diff --git a/arch/arm/dts/imx6qdl-hummingboard2-emmc-som-v15-u-boot.dtsi
b/arch/arm/dts/imx6qdl-hummingboard2-emmc-som-v15-u-boot.dtsi
index d302b2e275..b1364a0bbf 100644
--- a/arch/arm/dts/imx6qdl-hummingboard2-emmc-som-v15-u-boot.dtsi
+++ b/arch/arm/dts/imx6qdl-hummingboard2-emmc-som-v15-u-boot.dtsi
@@ -34,3 +34,7 @@
&usdhc1 {
status = "disabled";
};
+
+&usdhc2 {
+ u-boot,dm-pre-reloc;
+};
Have you tested boot from eMMC?
You would most likely need to add &usdhc3 to SPL DT for that.
Good point. I haven't tested booting from eMMC as I can only boot from
SD because of eFuse settings. However after re thinking it should be
still possible to test it by keeping SPL on SD and placing U-Boot on eMMC.
Regards,
Walter
baruch
diff --git a/configs/mx6cuboxi_defconfig b/configs/mx6cuboxi_defconfig
index 23ce485f43..ae8d920260 100644
--- a/configs/mx6cuboxi_defconfig
+++ b/configs/mx6cuboxi_defconfig
@@ -24,6 +24,7 @@ CONFIG_USE_PREBOOT=y
CONFIG_PREBOOT="if hdmidet; then usb start; setenv stdin serial,usbkbd; setenv
stdout serial,vga; setenv stderr serial,vga; else setenv stdin serial; setenv stdout
serial; setenv stderr serial; fi;"
CONFIG_BOUNCE_BUFFER=y
CONFIG_BOARD_EARLY_INIT_F=y
+CONFIG_SPL_SEPARATE_BSS=y
CONFIG_SPL_FS_EXT4=y
CONFIG_SPL_I2C_SUPPORT=y
CONFIG_SPL_WATCHDOG_SUPPORT=y
@@ -36,6 +37,7 @@ CONFIG_CMD_CACHE=y
CONFIG_CMD_EXT4_WRITE=y
# CONFIG_SPL_PARTITION_UUIDS is not set
CONFIG_OF_CONTROL=y
+CONFIG_SPL_OF_CONTROL=y
CONFIG_DEFAULT_DEVICE_TREE="imx6dl-hummingboard2-emmc-som-v15"
CONFIG_OF_LIST="imx6dl-hummingboard2-emmc-som-v15
imx6q-hummingboard2-emmc-som-v15"
CONFIG_MULTI_DTB_FIT=y
@@ -44,6 +46,7 @@ CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG=y
CONFIG_NET_RANDOM_ETHADDR=y
CONFIG_DM=y
+CONFIG_SPL_DM=y
CONFIG_DWC_AHSATA=y
CONFIG_DM_GPIO=y
CONFIG_DM_MMC=y