Currently ATA commands are defined both in include/libata.h and
include/ata.h. libata.h is included in ata.h. So this duplication does
not make much sense.
Use the command definitions from include/libata.h where applicable.
Signed-off-by: Heinrich Schuchardt <xypron.g...@gmx.de>
---
drivers/block/ide.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/block/ide.c b/drivers/block/ide.c
index 4b8a4eac17..67cc4fbc02 100644
--- a/drivers/block/ide.c
+++ b/drivers/block/ide.c
@@ -231,7 +231,7 @@ unsigned char atapi_issue(int device, unsigned char *ccb,
int ccblen,
(unsigned char) ((buflen >> 8) & 0xFF));
ide_outb(device, ATA_DEV_HD, ATA_LBA | ATA_DEVICE(device));
- ide_outb(device, ATA_COMMAND, ATAPI_CMD_PACKET);
+ ide_outb(device, ATA_COMMAND, ATA_CMD_PACKET);
udelay(50);
mask = ATA_STAT_DRQ | ATA_STAT_BUSY | ATA_STAT_ERR;
@@ -570,7 +570,7 @@ static void ide_ident(struct blk_desc *dev_desc)
/*
* Start Ident Command
*/
- ide_outb(device, ATA_COMMAND, ATAPI_CMD_IDENT);
+ ide_outb(device, ATA_COMMAND, ATA_CMD_ID_ATAPI);
/*
* Wait for completion - ATAPI devices need more time
* to become ready
@@ -582,7 +582,7 @@ static void ide_ident(struct blk_desc *dev_desc)
/*
* Start Ident Command
*/
- ide_outb(device, ATA_COMMAND, ATA_CMD_IDENT);
+ ide_outb(device, ATA_COMMAND, ATA_CMD_ID_ATA);
/*
* Wait for completion
@@ -966,7 +966,7 @@ ulong ide_read(struct blk_desc *block_dev, lbaint_t blknr,
lbaint_t blkcnt,
/* first check if the drive is in Powersaving mode, if yes,
* increase the timeout value */
- ide_outb(device, ATA_COMMAND, ATA_CMD_CHK_PWR);
+ ide_outb(device, ATA_COMMAND, ATA_CMD_CHK_POWER);
udelay(50);
c = ide_wait(device, IDE_TIME_OUT); /* can't take over 500 ms */
--
2.25.0
