On 2/19/20 7:55 PM, Marek Vasut wrote: > From: Holger Brunck <holger.bru...@ch.abb.com> > > Add initial support for the ABB SECU board, which is an ArriaV-based > SoCFPGA system with ethernet and booting from Denali NAND. > > Signed-off-by: Holger Brunck <holger.bru...@ch.abb.com> > Cc: Ley Foon Tan <ley.foon....@intel.com> > Cc: Simon Goldschmidt <simon.k.r.goldschm...@gmail.com> > --- > V2: Use CONFIG_SYS_I2C_EEPROM_ADDR in printf() in ivm.c > Enable CONFIG_SYS_NAND_USE_FLASH_BBT > --- > arch/arm/dts/Makefile | 1 + > arch/arm/dts/socfpga_arria5_secu1.dts | 130 +++++ > arch/arm/mach-socfpga/Kconfig | 10 + > board/keymile/Kconfig | 11 +- > board/keymile/common/ivm.c | 19 +- > board/keymile/secu1/Makefile | 7 + > board/keymile/secu1/qts/iocsr_config.h | 694 ++++++++++++++++++++++++ > board/keymile/secu1/qts/pinmux_config.h | 218 ++++++++ > board/keymile/secu1/qts/pll_config.h | 83 +++ > board/keymile/secu1/qts/sdram_config.h | 327 +++++++++++ > board/keymile/secu1/socfpga.c | 67 +++ > configs/socfpga_secu1_defconfig | 84 +++ > include/configs/socfpga_arria5_secu1.h | 131 +++++
So, this is missing MAINTAINERS file. I will just manually add it: $ cat board/keymile/secu1/MAINTAINERS ABB SECU1 BOARD M: Holger Brunck <holger.bru...@ch.abb.com> S: Maintained F: include/configs/socfpga_arria5_secu1.h F: configs/socfpga_secu1_defconfig is that OK ?