Remy Bohmer wrote: > Hi Stefano, > Hi Remy,
> Indeed, this seems to be some debug logging that can be removed... Ok, understood. > We have tested it with the Atmel at91sam9261 core, and I have never > used it with any other hardware. > It is possible that you run into problems here that where not visible > on the Atmel core... yes, this is what I have seen... > >> I report the whole log, enabling debug output on both musb driver and >> ether.c. Do you have some hints to give me to go further ? > > This is my log when I do a (successful) ping to the host when I run on > a Atmel eval-kit. > Maybe you can use it as reference? Maybe it helps... Thanks a lot, it really helped me ;-). At least, I can now identify what a real problem is and what is not.. I can now complete the setup phase and the interface is working. I have found a couple of problems in ether.c that I will report to you. Of course, if you agree with my analyses, I will send patches to fix them. 1. The status_req buffer is static allocated as u8. However, in eth_status_complete is referenced with a 32 bit pointer: __le32 *data = req->buf In most case the buffer is not 32-bit aligned and causes an exception. 2. In eth_bind a wrong ep is allocated. #if defined(DEV_CONFIG_CDC) if (dev->status_ep) { dev->stat_req = usb_ep_alloc_request(gadget->ep0, GFP_KERNEL); This should be: dev->stat_req = usb_ep_alloc_request(dev->status_ep, GFP_KERNEL); 3. Not sure about the handling in usb_eth_send. I do not know if the fix I propone works only for the musb driver or could be general and it was to me not clear as the packet_sent variable is managed: 1834 while(!packet_sent) 1835 { 1836 packet_sent=0; 1837 } It seems there is no possibility to change packet_sent if we run in the loop.... I managed to call handle_interrupts() inside the loop to get it working. I can only assume that on your Atmel Core, tx_complete is called directly after running into usb_ep_queue, and then you have not this issue. But for most drivers, it should be required to call the interrupt routine (or something like that, but we have already handle_interrupts()) to manage all events. Best regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot