Dear Rogan Dawes, In message <4c69a8da.8020...@dawes.za.net> you wrote: > > > Are you absolutely sure that you have RAM in your system at 0x8000? > > I doubt that your Load Address/Entry Point settings are correct. > > This is the default kernel that was shipped with the device, and so > those are the settings that worked with the original u-boot.
Why do you not simply answer the question I asked? Why do you not think about what I asked, and why? > >>> Verifying Checksum ... Bad Data CRC > >>> Ramdisk image is corrupt or invalid > > > > Is there RAM at 0x00800000 ? > > Again, this is from the default vendor ramdisk that ships with the device. Why should I care about where this is coming from? On such a base I cannot help you. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Steal five dollars and you were a petty thief. Steal thousands of dollars and you are either a government or a hero. - Terry Pratchett, _Going_Postal_ _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot