Add dt-binding for MediaTek xHCI host controller
Signed-off-by: Chunfeng Yun <chunfeng....@mediatek.com>
Reviewed-by: Weijie Gao <weijie....@mediatek.com>
---
v7: no changes
v6: add Reviewed-by Weijie
v2~v5: no changes
---
.../usb/mediatek,mtk-xhci.txt | 40 +++++++++++++++++++
1 file changed, 40 insertions(+)
create mode 100644 doc/device-tree-bindings/usb/mediatek,mtk-xhci.txt
diff --git a/doc/device-tree-bindings/usb/mediatek,mtk-xhci.txt
b/doc/device-tree-bindings/usb/mediatek,mtk-xhci.txt
new file mode 100644
index 0000000000..0447468a2d
--- /dev/null
+++ b/doc/device-tree-bindings/usb/mediatek,mtk-xhci.txt
@@ -0,0 +1,40 @@
+MediaTek xHCI
+
+The device node for USB3 host controller on MediaTek SoCs.
+
+Required properties:
+ - compatible : should be "mediatek,mtk-xhci"
+ - reg : specifies physical base address and size of the registers
+ - reg-names: should be "mac" for xHCI MAC and "ippc" for IP port control
+ - power-domains : a phandle to USB power domain node to control USB's
+ MTCMOS
+ - vusb33-supply : regulator of USB avdd3.3v
+
+ - clocks : a list of phandle + clock-specifier pairs, one for each
+ entry in clock-names
+ - clock-names : must contain
+ "sys_ck": controller clock used by normal mode,
+ the following ones are optional:
+ "ref_ck": reference clock used by low power mode etc,
+ "mcu_ck": mcu_bus clock for register access,
+ "dma_ck": dma_bus clock for data transfer by DMA,
+ "xhci_ck": controller clock
+
+ - phys : list of all the USB PHYs on this HCD
+ - phy-names: name specifier for the USB PHY
+
+Optional properties:
+ - vbus-supply : reference to the VBUS regulator;
+
+Example:
+xhci: usb@1a0c0000 {
+ compatible = "mediatek,mt7629-xhci", "mediatek,mtk-xhci";
+ reg = <0x1a0c0000 0x1000>, <0x1a0c3e00 0x0100>;
+ reg-names = "mac", "ippc";
+ power-domains = <&scpsys MT7629_POWER_DOMAIN_HIF1>;
+ clocks = <&ssusbsys CLK_SSUSB_SYS_EN>, <&ssusbsys CLK_SSUSB_REF_EN>,
+ <&ssusbsys CLK_SSUSB_MCU_EN>, <&ssusbsys CLK_SSUSB_DMA_EN>;
+ clock-names = "sys_ck", "ref_ck", "mcu_ck", "dma_ck";
+ phys = <&u2port0 PHY_TYPE_USB2>, <&u3port0 PHY_TYPE_USB3>;
+ status = "disabled";
+};
--
2.25.1
