Hello Simon,
Am 22.04.2020 um 18:13 schrieb Simon Glass:
At present we still have pre-driver-model code in this driver and it makes
things a bit confusing. In particular calc_bus_speed() is called with priv
as NULL if not using driver model.
This results in spk_cnt and comp_param1 being read from an invalid address
if not using driver model. For comp_param1 this may not cause problems if
reading from addresses close to 0 happens to be allowed, as high speed is
only supported by DM code. But spk_cnt is subsequently used to calculate
the bus periods and so this may cause problems (e.g. on spear600 board
which has not been migrated yet).
Add a new parameter regs parameter to calc_bus_speed() and add more
comments to this function and to _dw_i2c_set_bus_speed(), which calls it.
Signed-off-by: Simon Glass <s...@chromium.org>
Reported-by: Heinrich Schuchardt <xypron.g...@gmx.de>
---
drivers/i2c/designware_i2c.c | 34 +++++++++++++++++++++++-----------
1 file changed, 23 insertions(+), 11 deletions(-)
Applied to u-boot-i2c master
Thanks!
bye,
Heiko
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-52 Fax: +49-8142-66989-80 Email: h...@denx.de
