Since commit:
commit 6333cbb3817ed551cd7d4e92f7359c73ccc567fc
Author: Michael Walle <mich...@walle.cc>
Date: Thu May 7 00:11:58 2020 +0200
phy: atheros: ar8035: remove static clock config
We can configure the clock output in the device tree. Disable the
hardcoded one in here. This is highly board-specific and should have
never been enabled in the PHY driver.
If bisecting shows that this commit breaks your board it probably
depends on the clock output of your Atheros AR8035 PHY. Please have a
look at doc/device-tree-bindings/net/phy/atheros.txt. You need to set
"clk-out-frequency = <125000000>" because that value was the hardcoded
value until this commit.
Signed-off-by: Michael Walle <mich...@walle.cc>
Acked-by: Joe Hershberger <joe.hershber...@ni.com>
, the clock output setting for the AR803x driver is removed from being
hardcoded in the PHY driver and should be passed via device tree instead.
Update the device tree with the "qca,clk-out-frequency" property so that
Ethernet can work again.
Reported-by: Soeren Moch <sm...@web.de>
Signed-off-by: Fabio Estevam <feste...@gmail.com>
---
Changes since v1:
- Removed extra unnecessary extra blank line from device tree.
arch/arm/dts/imx6q-tbs2910.dts | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/arch/arm/dts/imx6q-tbs2910.dts b/arch/arm/dts/imx6q-tbs2910.dts
index cc5df37b46..7d0a0676ff 100644
--- a/arch/arm/dts/imx6q-tbs2910.dts
+++ b/arch/arm/dts/imx6q-tbs2910.dts
@@ -107,7 +107,18 @@
pinctrl-0 = <&pinctrl_enet>;
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
+ phy-handle = <&phy>;
status = "okay";
+
+ mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ phy: ethernet-phy@4 {
+ reg = <4>;
+ qca,clk-out-frequency = <125000000>;
+ };
+ };
};
&hdmi {
--
2.17.1
