U-Boot on QEMU-arm64 can be used in two configurations: Loaded directly via QEMU's -bios option, or as a non-secure payload (BL33) via ARM Trusted Firmware-A (TF-A). In the latter case we need to define CONFIG_TFABOOT, to accommodate the first flash bank being secure only, and manually set SYS_TEXT_BASE to the address configured in TF-A (currently 0x60000000).
To avoid this poorly documented adventure, we enable a position independent build, and also let the flash regions be always detected through the DTB. This results in a single build to work under both scenarios, and also allows to move the BL33 load address in TF-A to something lower in the future. For this to work, we have to first make PIE work when booted from ROM. While writing to ROM should not hurt, it might trigger CFI flash sequences, and indeed crashes for me in the middle of the fixup routine. This is covered by patch 1/5, which skips the whole fixup routine if the offset is actually 0 (as it is in our case). Also we have to decouple the relative initial stack pointer from the PIE option, as we always need to use the fixed version, pointing to RAM (patch 2/5). Patch 3/5 drops the hard-coded flash address, instead U-Boot can already read all required information from QEMU's DTB. Patch 4/5 is a cleanup, while the last patch enables the PIE build. With this series the very same u-boot.bin file works when directly loaded from the QEMU command line (-bios), but also when embedded into TF-A's fip.bin, removing the need for case-specific build options. Please have a look! Cheers, Andre Andre Przywara (5): arm64: PIE: Skip fixups if distance is zero arm64: PIE: Allow fixed stack pointer qemu-arm: Remove need to specify flash banks qemu: Drop ARCH_SUPPORT_TFABOOT qemu/arm64: Enable POSITION_INDEPENDENT arch/arm/Kconfig | 4 ++-- arch/arm/cpu/armv8/start.S | 3 ++- configs/qemu_arm64_defconfig | 1 + include/configs/qemu-arm.h | 8 +------- 4 files changed, 6 insertions(+), 10 deletions(-) -- 2.17.5
